Cisco packet tracer (site to site IPsec VPN using CLI)

[anonimousjs]

Hello everyone. Is there anyone who can solve my task?

The task is to configure and verify site-to-site IPsec VPN using CLI, and if you decided to do, please note that student ID is 44331. It is very IMPORTANT))

[Martin L]

PT has a lots of samples of config under File >open samples; one of them is site to site vpn; you just need to change few things to match your requirements.

[dinns]

Hi,

We can help, however, this sounds an academy assignment. You need to configure it yourself to understand fundamentals of IPSEC Site to Site VPN.  Below is sample configuration of Phase1,  continue it with Phase2 etc. help yourself and put efforts Once you complete the configuration and encounter problem, post here so we can help you further. thanks 

!

crypto isakmp policy 1
encr 3des
authentication pre-share
group xx
crypto isakmp key xxx address x.x.x.x

[anonimousjs]

Yes, you are right, this is a task from my university. But, I study here backend and frontend web app development, and for now I am not planning to learn cisco. If you help me, then, I can help you too to create some small websites if you have a need :)

can you help me?

[Georg Pauwen]

Hello,

have a look at the project attached. If you cannot open it, I'll send the configurations over...

[anonimousjs]

thank you so much, I just sent it to my teacher to confirm it. If I will have any questions I will ask again :) have a good day