04-06-2011 06:51 PM - edited 03-06-2019 04:29 PM
HI ,
I have configured port secuirty on Cisco 4510R with Sup V and 4506 with Sup II plus (maximum mac address 2) .I have connect like below
Laptop-----IP Phone-----Switch. while I unplugged Laptop and plug in another port in same switch (4506 with SUP II plus) MAC automatically flushes the Laptop MAC in old port and taking the same MAC in new port without Aging.But in 4501R MAC is not flushing without aging time.I want to know whether Port secuirty is dependant with Hardware Architecture....
pls help...
regards,
Ajith
04-07-2011 12:28 AM
Hi,
I hope the below link will tell you the process of port security.
http://www.techrepublic.com/article/lock-down-cisco-switch-port-security/6123047
Please rate the helpfull posts.
Regards,
Naidu.
04-07-2011 12:47 AM
hi,
there's a command which can set the aging time for the MAC address table. nothing to do with the switch hardware. i suspect your 4501R's aging time is disabled (set to 0). could you post both 4510R's and 4506's output as per below?
Switch#sh run | i aging
04-08-2011 05:01 AM
Both Switches Aging time is 0 only...I have checked in two switches
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide