Cisco REP ring not working

[jasonliur932095]

Hi there, 

I have four IE2000 switches to form a REP ring.

One of four switch has 2 edge ports, 1 primary edge port , 1 secondary edge port, both configured as trunk port.

All the ports used for the REP (the other 3 switches) have been assigned a segment ID, and configured as trunk port.  

But it didnt work. Could anyone help me? Attached Packet Tracer file.

I appreicate your help.

[Georg Pauwen · Accepted solution]

Hello,

what exactly does not work ? The topology looks good:

Switch#sh rep topology
REP Segment 3
BridgeName PortName Edge Role
---------------- ---------- ---- ----
Switch Gig1/1 Pri Open
Switch Gig1/2 Sec Alt
Switch Gig1/1 Open
Switch Gig1/2 Open
Switch Gig1/1 Open
Switch Gig1/2 Open
Switch Gig1/1 Open
Switch Gig1/2 Open

[jasonliur932095]

thanks looks like there is a big lag to the packet tracer software...