Cisco Resilient Ethernet Protocol (REP) and link redundancy

[pat.mar.paj]

Hello.

My name is Patricia, from Spain. I would like to know if Cisco Resilient Ethernet Protocol (REP) supports aggregated ports (EtherChannel) in the ring segment.

Another question is if Cisco REP supports double-ring topologies (two one-way rings).

Thank you very much.

[Latchum Naidu · Accepted solution]

Hi,

REP is supported on EtherChannels, but not on an individual port that belongs to an EtherChannel.
And REP is supported only on Layer 2 trunk interfaces.

Please see the below link for more information about Cisco REP's

http://www.cisco.com/en/US/docs/switches/metro/me3400/software/release/12.2_52_se/configuration/guide/swrep.html

Hope this helps you..
Please rate the helpfull posts.

Regards,
Naidu.

[Chetanpadshala]

Hello Guys,

we are imoplementing rep segment on two Cisco cat 4948E and Cisco ASR 9001. If anyone can  help me on this imolementation. Click below link i have posted a question along with configurations and diagram. help wud be appreciated.

Thank you. 

https://supportforums.cisco.com/discussion/13274346/urgent-implementing-represilient-ethernet-protocol-between-two-cisco-4948e-and