Dear Cisco mates.
I have a issue with Vlan on switch SG300 and Ubiquiti PowerBeam.
So. I tried to connect two switches on trunk mode both. Valn 7 cctv and vlan 9 mgmt vlan set as native.
PowerBeam set on advance mode with bridges to vlan 7 and 9 (lan 9 bridge to WAN 9 and lan 7 to wan 7).
I can ping switch 10.113.109.91 all three POwerbeam, cctv camera on other side but no access to switch 10.113.109.98.
PLS Help.
Diagram attached.
Regards
