Hi, I'm a little doubt, I have a sg200-10fp poe 8 ports, 2 ports are SFP that and the fiber connection, (obviously with a separate connector), the function of these ports and connect 2 switches without having problems of latency long distance, my question is:
If your ISP (Internet service provider) takes you to the FTTH Fiber home and you can use these ports or need a modem that supports VDSL2 + and that manages communications?
That really depends on your ISP. My ISP uses long haul fiber I had to get a special SFP from them. The SG200 doesn't have NAT capability so not sure what you are trying to do with it but if the idea is to have everything share the internet while plugged in that may not work.
Hi Guys, I have two questions about EIGRP behavior when we have Multiple EIGRP routes: 1- I tried to show on some router the acquired EIGRP paths for a route X.X.X.X by typing the command : "show ip eigrp topology X.X.X.X". On the output there w...
[ The Discussion forum will be published on December 1st ]
Take the opportunity to reach out to our expert and discuss best practices regarding on how to troubleshoot a live network and identify the root cause easily. Learn more about Serviceability and h...
To provide a solution to quickly setup a router at a remote location that supports WiFi and provides instant internet access using LTE as a transport while deploying with Cisco SD-WAN.
Plug the router to a power sou...
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...