We currently have Cisco WS-X6708-10GE blade installed in our Cisco 7606-S switch. Each of the ports have a X2-10GB-SR tranciever. When I look at the port with the "sh int tengig xx" command I see the following:
!
TenGigabitEthernet 4/1 is up, line protocol is up (connected)
Hardware is c7600 10Gb 802.3, address is 001c.b0ca.75c0
!
TenGigabitEthernet 4/2 is up, line protocol is up (connected)
Hardware is c7600 10Gb 802.3, address is 001c..b0ca.75c0
!
TenGigabitEthernet 4/3 is up, line protocol is up (connected)
Hardware is c7600 10Gb 802.3, address is 001a.6c9e.e1fa
!
TenGigabitEthernet 4/4 is up, line protocol is up (connected)
Hardware is c7600 10Gb 802.3, address is 001a.5c9e.e1fb
!
TenGigabitEthernet 4/5 is up, line protocol is up (connected)
Hardware is c7600 10Gb 802.3, address is 001a.5c9e.e1fc
!
TenGigabitEthernet 4/5 is up, line protocol is up (connected)
Hardware is c7600 10Gb 802.3, address is 001a.5c9e.e1fd
!
TenGigabitEthernet 4/6 is up, line protocol is up (connected)
Hardware is c7600 10Gb 802.3, address is 001c.b0ca.75c0
!
TenGigabitEthernet 4/6 is up, line protocol is up (connected)
Hardware is c7600 10Gb 802.3, address is 001c.b0ca.75c0
!
Why does do the following ports show the same hardware address - 001c.b0ca.75c0?
TenGigabitEthernet 4/1
TenGigabitEthernet 4/2
TenGigabitEthernet 4/6
TenGigabitEthernet 4/7
Can this be changed?
