11-11-2013 10:04 AM - edited 03-07-2019 04:32 PM
Hi
I am very new to here and having hard time understand some IOS commands.
I am using
IOS (tm) 3700 Software (C3745-SPSERVICESK9-M), Version 12.3(16), RELEASE SOFTWARE (fc4)
my current vty config has only
line vty 0 4
exec-timeout 0 20
!
when I try to do > login local on this vty line I am getting follwonig error.
'
(config-line)#login local
^
% Invalid input detected at '^' marker.
But when I do telnet it's asking for username/passowd and I can login using the following config
username xxxxxx privilege 15 password 7 934805983058
Now I don't understand that without having 'login local' in vty config why my router is asking for username/pass....
Thanks in advance...
Solved! Go to Solution.
11-11-2013 11:05 AM
Under vty lines if you are unable to configure" login local" then it means you have aaa configured on the switch.
Can you check "show run | in aaa"?
Thanks & Regards,
Karthick Murugan
CCIE#39285
11-11-2013 11:05 AM
Under vty lines if you are unable to configure" login local" then it means you have aaa configured on the switch.
Can you check "show run | in aaa"?
Thanks & Regards,
Karthick Murugan
CCIE#39285
11-11-2013 12:28 PM
Thanks Karthick.....
once I removed the aaa config I am able to use 'login local' command.....
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide