02-15-2012 07:34 AM - edited 03-07-2019 04:57 AM
Hi All,
Is there any command that shows all the line cards model that have been installed for each 4500 slot?
The "show interface" command is not enough as for example it will not allow to understand if it's a classic or a E-Series line card.
Thanks,
Vin
Solved! Go to Solution.
02-15-2012 07:40 AM
Hi Vin,
show module is good command to reveal details about switch related cards
show diag is a good for the Cisco rotuer environment
If helpful, rate it!!
Regards
Frank
02-15-2012 07:48 AM
Show idprom all or show mod will show you what you need .
02-15-2012 07:40 AM
Hi Vin,
show module is good command to reveal details about switch related cards
show diag is a good for the Cisco rotuer environment
If helpful, rate it!!
Regards
Frank
02-15-2012 07:47 AM
Thanks, exactly what I was looking for!
Post rated.
Regards,
Vin
02-15-2012 07:48 AM
Show idprom all or show mod will show you what you need .
02-16-2012 01:27 AM
I'm using:
#show inventory
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: