Command to confirm RP in Router

[mahesh18]

Hi Everyone,

Need to confirm to know RP for the multicast group I can run the below command

show ip pim rp
Group: 224.0.1.40, RP: 10.2.10.1, v2, uptime 1y2w, expires never

Regards

MAhesh

[MUHAMMAD TAYYAB MUNIR]

Hi,

Check below command which is " show ip mroute or show ip mroute vrf IPTV"

PE-7609-XX-01#show ip mroute vrf IPTV
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry, E - Extranet,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report,
Z - Multicast Tunnel, z - MDT-data group sender,
Y - Joined MDT-data group, y - Sending to MDT-data group,
G - Received BGP C-Mroute, g - Sent BGP C-Mroute,
Q - Received BGP S-A Route, q - Sent BGP S-A Route,
V - RD & Vector, v - Vector
Outgoing interface flags: H - Hardware switched, A - Assert winner
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode

(*, 225.1.1.84), 7w0d/stopped, RP X.X.X.X, flags: SPF ---------> X represent to RP IP
Incoming interface: Vlan10, RPF nbr X.X.X.X
Outgoing interface list: Null

Regards

Tayyab