10-03-2014 11:27 AM - edited 03-07-2019 08:58 PM
Hi,
Is there any command to verify SFP or QSFP port LED status on L2 or L3 switches from remote location ?
10-03-2014 03:30 PM
If your appliance has all the correct HTML files loaded, the fastest way is to just use a web browser. Enter the management IP address of your switch to your web browser (and ensure HTTP/HTTPS is enabled).
10-05-2014 01:29 AM
Hi Leo,
Thanks for your reply.
I can able to enter into device via MGMT IP, But I need to know the SFP or QSFP port LED status whether it's (green or orange) from Command prompt.
Thanks
Neelesh
10-05-2014 07:48 AM
There is no single CLI command that can accomplish this.
You will need multiple CLI commands and depends on how the interface is configured.
10-05-2014 11:17 PM
Oh OK then better I will verify some document.
Anyway thanks Leo.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide