10-03-2014 11:27 AM - edited 03-07-2019 08:58 PM
Hi,
Is there any command to verify SFP or QSFP port LED status on L2 or L3 switches from remote location ?
10-03-2014 03:30 PM
If your appliance has all the correct HTML files loaded, the fastest way is to just use a web browser. Enter the management IP address of your switch to your web browser (and ensure HTTP/HTTPS is enabled).
10-05-2014 01:29 AM
Hi Leo,
Thanks for your reply.
I can able to enter into device via MGMT IP, But I need to know the SFP or QSFP port LED status whether it's (green or orange) from Command prompt.
Thanks
Neelesh
10-05-2014 07:48 AM
There is no single CLI command that can accomplish this.
You will need multiple CLI commands and depends on how the interface is configured.
10-05-2014 11:17 PM
Oh OK then better I will verify some document.
Anyway thanks Leo.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: