Commands for monitoring and troubleshooting qos in cat 6500

[kaustav.gupta]

Hi I am trying to implement qos on catalyst 6500 with WS-6148 A - Ge-45AF line card. I have configured qos on the port levels but not finding any suitable command other than sh queueuing int g slot/port in order to see the various COS marked traffic entrring the queue /threshold combinations.

Kindly help.

Kas

[Edison Ortiz · Accepted solution]

If you enable and configure NetFlow you can see the QoS markings (in hex) while issuing the show mls ip detail command.

This URL is also helpful http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008074d6b1.shtml

Regards

Edison