Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have a setup where we have 2 Nexus 9K's connected with 2 Fabric Interconnect. In the Port channels in the Nexus 9K will it be spanning-tree port type network or it will be spanning-tree port type edge trunk ? Logically if i treat the Fabric In...
Hello,
Does anybody know if somebody hijacks a BGP prefix where to register a complaint ? So if the incident happened in APNIC region will it be APNIC ? ANy help appreciated..
Thanks
Zak
Hi,I am trying to figure out how can I NAT the source IP address of Outside hosts in the ASA when they try to access a router located in the Inside network so that I do not have to put a route pointing back for those Outside subnet's in the router. ...
I have a router connected to a provider via POS and once we commissioned the link we are receiving the following logs010091: .May 7 06:58:34.353 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface POSx/x/x, changed state to down010092: .May 7 06:59:...
sh int pos 0/1/0POS0/1/0 is up, line protocol is up Hardware is SPA-1XOC12-POS MTU 4470 bytes, BW 622000 Kbit/sec, DLY 100 usec, reliability 255/255, txload 1/255, rxload 4/255 Encapsulation FRAME-RELAY IETF, crc 32, loopback not set Keepali...
HI sandeep ,I was really looking for this commands as it is an LWAPP image.I configured and IP address in the AP and the output changed to *Jan 19 21:09:54.739: %CAPWAP-3-ERRORLOG: Go join a capwap controllerexamining image...!extracting info (286 b...
