cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
27710
Views
2
Helpful
2
Replies

Commands To Show Current MTU Value on Cisco 2821

Hello all,

I was wanting to know the command(s) needed to show the current MTU value in a 2821 router.

Thanks in advance

1 Accepted Solution

Accepted Solutions

Peter Paluch
Cisco Employee
Cisco Employee

Willie,

There is no single MTU setting for a 2821 router. Each IP-enabled interface can have its own independent MTU. Therefore, you should check each interface separately. The commands:

show interfaces X

show ip interface X

Look for MTU in the output. Replace X with the name and number of the interface you are interested in.

Best regards,

Peter

View solution in original post

2 Replies 2

Peter Paluch
Cisco Employee
Cisco Employee

Willie,

There is no single MTU setting for a 2821 router. Each IP-enabled interface can have its own independent MTU. Therefore, you should check each interface separately. The commands:

show interfaces X

show ip interface X

Look for MTU in the output. Replace X with the name and number of the interface you are interested in.

Best regards,

Peter

You are correct Paul, thanks a bunch

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: