config intarface switch

[Akram09]

Hi I attached a diagram for clarification -
What should be the interface setting you connect to (Mimosa Link Client) access or tunk?
 What about the rest of the interfaces? To note, I use one VLAN inside the switch 

[MHM Cisco World]

Only one vlan in SW then wifi bridge interface will be access.

More tha  one vlan in SW then you need to use trunk 

MHM

[M02@rt37]

Hello @Akram09 

Do it weel at the beginning and for future configuration. Configure a Trunk port between the 2 sites. Configure access port where endpoints are connected to.