Config NTP

danilopasiani1 · ‎10-09-2015

Hello,

I need some help.

I am trying to configuring NTP on the switch in my company.

There is a NTP server in my company with IP 10.38.1.24.

I configured the switch in my company like this config below.

ntp server 10.38.1.24

09:26:11.652 BR Fri Oct 9 2015

But the time is not correct like the server.

sh ntp associations

address ref clock st when poll reach delay offset disp
~10.38.1.24 .INIT. 16 - 1024 0 0.000 0.000 15937.
* sys.peer, # selected, + candidate, - outlyer, x falseticker, ~ configured

Some one know why the time is not the same NTP server?

Need I configure more things ?

Regards,

Danilo

Joseph W. Doherty · ‎10-09-2015

The server is a "true" NTP server, not a Windows time server?

danilopasiani1 · ‎10-09-2015

I checked with server team and they said that this is a Windowns NTP server.

Ganesh Hariharan · ‎10-09-2015

Hello,


I need some help.


I am trying to configuring NTP on the switch in my company.


There is a NTP server in my company with IP 10.38.1.24.


I configured the switch in my company like this config below.


ntp server 10.38.1.24

09:26:11.652 BR Fri Oct 9 2015


But the time is not correct like the server.


sh ntp associations 

  address         ref clock       st   when   poll reach  delay  offset   disp
 ~10.38.1.24      .INIT.          16      -   1024     0  0.000   0.000 15937.
 * sys.peer, # selected, + candidate, - outlyer, x falseticker, ~ configured


Some one know why the time is not the same NTP server?

Need I configure more things ?

Regards,

Danilo

Hi Danilo,

What is show ntp association details commands shows..

and check out the below link for more details and information with w32 time sync service with NTP devices.

https://supportforums.cisco.com/document/7176/ntp-common-issues-and-troubleshooting#Sync_to_W32_based_time_service_Most_Windows_Implimentations

Hope it Helps..

-GI

Rate if it Helps..