05-20-2013 02:13 PM - edited 03-10-2019 12:22 PM
This is probably a dumb question, but I have read the 2960 stack administration guide and it does not explain how to configure the stack IP address. It says several times that the stack can be managed from the stack IP address, and that the stack IP address is a system-level configuration item. But it never explains how to configure the stack IP address. Can anyone help?
Solved! Go to Solution.
05-20-2013 02:22 PM
Pick a vlan as your management vlan and configure the SVI for it:
Example:
vlan 20
name mgmt-vlan
exit
inter vlan 20
ip address 10.10.10.1 255.255.255.0
no sh
Then add this vlan to your trunk unless you are allowing all vlans.
verify the vlan is up and up
sh ip int bri vlan20
HTH
05-20-2013 02:22 PM
Pick a vlan as your management vlan and configure the SVI for it:
Example:
vlan 20
name mgmt-vlan
exit
inter vlan 20
ip address 10.10.10.1 255.255.255.0
no sh
Then add this vlan to your trunk unless you are allowing all vlans.
verify the vlan is up and up
sh ip int bri vlan20
HTH
05-20-2013 02:34 PM
Thank you very much.
05-20-2013 05:59 PM
Glad to help and thanks for the rating
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide