I am working on configuring the Archive command on 6509e VSS (VS40) and hit a snag that caused my slave 6509e to reload in rommon
Here is the config that caused this failure: Archive
After I did my copy run start the secondary slave detected a configuration mismatch and reloaded. I had to remove the code above and copy run start again in order to get matching configurations and VSS re-established.
I presume it has to do with the bootdisk command however I am trying to find the configuration example from Cisco.com or other VSS guide / Archive command guides without success.
Do I simply need to add 2 paths for the archive as such:
The 2020 IT Blog Awards, hosted by Cisco, is now open for submissions through October 16. Submit your blog, vlog or podcast today. For more information, including category details, the process, past winners and FAQs, check out: https://www.cisco...
Hello,We have a pair of N3K-3064PQ-10GX and one of them acting as backup and we want to migrate from VyOS to it, we want to add 500x interface vlan and each interface vlan has its own ip/prefixes (for example /30 /29 ...) and we ahve 6-8x BGP session with...
We live in an age that is both thrilling and evolving substantially. A new trend/technology is always on rise even before the preceding has been used to its fullest potential. Although the concepts of digital transformation may seem over discussed, ...
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.