- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2021 10:26 PM
I am configuring a DHCP Server for a small VLAN.
I have configured vlan 10 20 30 and trunk access for switch interfaces, activated fa0/0.1, fa0/0.2, fa0/0.3 as example below
int fa0/0.1 encapsulation dot1Q 10 ip address 192.168.10.1 255.255.255.0 ip helper-address 192.168.1.2
However, the PCs cannot fetch IP address.
This is my Cisco Packet Tracer file.
Solved! Go to Solution.
- Labels:
-
Branch Router
-
LAN Switching
-
Other Switches
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2021 11:52 PM
Hello,
both your servers have an IP address in the 192.168.1.0/24 range, but are assigned to Vlans 60 and 50. They need to be in the default vlan (1).
Attached the working, revised file.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2021 10:45 PM
I do not use PT, but what is device doing DCCP here ?
1. the Device connected to switch - that port should be Trunk and allow the VLAN
2. PC connected port should be VLAN 10 to get IP address (by default all ports in vlan1)
post configuration - show run to help you. (or wait any PT experts can help you)

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2021 11:52 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-27-2024 12:37 PM
Change the port number Server is not ping change the port of server.
and assign vlan 40 and Vlan 50
