Configure Voice VLAN through Cisco Prime

[doodles6970]

Hello,

I'm hoping someone may be able to help.

I've deployed Cisco Prime Infrastructure 3.2 into my environement. I'm currently using this for some RBAC Access for our helpdesk. We would like the ability for them to add voice VLAN's to ports for the VOIP phones.

I know the port configuration via the CLI for the interface but i can't seem to find an option to do this through PI.

The options I have is to configure, Routed Port, Static Access and dot1q trunk. I could in theory create a trunk port and only allow the 2 VLAN's but i don't see this as a solution.

Hoping someone can help me.

Ryan

[Mark Malone · Accepted solution]

Hi Just create a custom config push go to section

Configuration / Templates / Features & Technologies

Then create a cli template with the config required save it and then push it to the device
You could do a range command with all the voice ports required for each device like below

int range g1/0/1 - 22
switchport access voice vlana 10

[doodles6970]

Thanks very much Mark.
I was aware of this option but was kind of hoping to do it from the same menu. Thanks a lot.

Ryan