configuring cisco2901 - Page 2

theboywhocriedwolf · ‎06-14-2013

hello all,

i am about to configure cico 2901 with this set-up (attached file)..

how am i going to start with this? what do i need to know? if example i have the leased ip 125.212.33.x/30 what will i as management for the router? will i used NAT for this?

thanks

paul driver · ‎06-17-2013

Hello,

It seems you dont have physical connection -What are cable type are you connecting to this modem with?

Going back to the original question - what type of service are you receiving from your ISP?

res

Paul

Please don't forget to rate any posts that have been helpful.

Thanks.

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

theboywhocriedwolf · ‎06-17-2013

im not yet connecting the router to the modem.. i want to up it 1st by configuring its command..

do i need to connect the modem to the router before i can do command:

Router1(config)#int gigabitEthernet 0/1

Router1(config-if)#ip add 192.168.20.1 255.255.255.0

Router1(config-if)#no shut

?

theboywhocriedwolf · ‎06-17-2013

type of service is leased line