Connect VLANs from 2 switches via a router

[minhnhut12121]

Hi everyone as in the project attached, I want the Network Administrator to communicate with all the computers. I can just do it with the computers in Switch 1, I can't get Network Administrator to ping the computers in Switch 2(right). Could you please check and offer solution ?

Thank you!

[Georg Pauwen]

Hello,

this looks like a Packet Tracer project, post the .pkt file (rename it to .jpg first, otherwise the system won't let you upload)...

[minhnhut12121]

Thanks for the tip. I attached it as jpg, please change extension to pkt. Thanks so much

[Georg Pauwen]

Hello,

you are using the same address space on two sides of the router, 192.168.1.0 and 192.168.99.0. This doesn't work. What is the requirement ?

The easiest way to resolve this is to connect one switch to the other (as I have done in the project attached)...

[minhnhut12121]

there has to be a router connecting 2 switches. And all the vlans can communicate to each other. 

The network administrator can ping all the computers.

[Georg Pauwen]

Is the requirement to use the same address space on both switches ?

[minhnhut12121]

It doesn't say anything about that. Just use trunking, int vlan and encapsulation command. Here is the instruction file. I'm stuck at the last question at page 6.

"add a router between the two switches to allow all vlans to communicate with each other"

Thanks so much for your help.

[Georg Pauwen]

Hello,

just change the IP addresses of the computers connected to the switch on the right, as I have done in the attached project file:

[minhnhut12121]

is there any way we can keep the addresses?, because the requirement is like the figure in page 7.

[Georg Pauwen]

You need to use bridging...

[minhnhut12121]

Could you please tell how to do that?

So we can't make the computers on the right switch connected just using concepts in the pdf file?

Thanks

[Georg Pauwen]

Hello,

are you supposed to accomplish this task in Packet Tracer ? Packet Tracer has a very limited subset of commands, it does not support bridging.

[minhnhut12121]

yes i have to use packet tracer. But if there is no way to connect like this, so maybe the right computers can't get connected to the network using this topology. Because the question asks for what PC replies to Network Administrator?