Connection between switch and laptop/PC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-14-2024 11:05 AM
Good morning,
I am trying to connect a laptop and PC to a switch which is connected to a server. The connection will not work between the Laptop or PC to the switch, despite the DHCP being established and there is just one interface [FastEthernet0] for the network. I have attached the packet tracer screenshot below. I've spent a lot of time trying to understand why it won't work, and I could be missing something obvious but not sure. I have tried to ping the IP addresse of the server on command prompt but to no avail - both the laptop and PC are switched on.
- Labels:
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-14-2024 11:24 AM
did PC get IP from server? is it in the same subnet as server (i think i see server IP on 192.168.80.x/24) ? Is interface ON? is DHCP service enabled on server? there is a default range set up on DHCP service tab but service may have to be turn on;
if all above is true, all ports on switch must be in the same vlan x; by default vlan 1 is ok
Regards, ML
**Please Rate All Helpful Responses **
