If you are using a console connection you will need a terminal emulator. There are quite a few out there but windows usually ha a built in one called Hyperterminal - start menu -> Accessories -> hyperterminal.
Open this up, select the com port (usually com1) and then when it comes to the settings just change the baud rate to 9600.
Introduction to Routing ProtocolsStatic vs DynamicDistance Vector vs Link StateRoute Selection AlgorithmSingle Routing Protocol OnlyOpen Shortest Path First (OSPF)AreasRoute ConvergencePath SelectionMetric CalculationCharacteristicsEnhanced Interior Gatew...
Cisco DNA Center version 2.2.2.x includes the features and improvements that
New intelligence provides an easy, gradual, and complete adoption of SD-Access. Faster Cisco DNA Center set-up saves time and effort.
When using Cisco cellular modules with a SIM card an APN must be provided. The APN cannot be stored in the SIM card and is supplied by your SIM card provider. Cisco cellular software contains a database of well-known APNs based on the country and ...
Cisco 3850: IOS-XE/Firmware Upgrade
This procedure is aimed at Cisco 3850 switch ONLY.
IOS-XE Bundle Mode is not covered.
9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered.
Listen: https://smarturl.it/CCRS8E46Follow us: twitter.com/ciscochampionsIt’s been several years since the release of Cisco DNA Center, and it’s matured into a complete network management system, an automation and orchestration engine, an AI/ML analy...