12-23-2013 08:47 PM - edited 03-07-2019 05:13 PM
hello
having a problem with my router 3845 whenever i am trying to reload with below command "copy flash:XXX startup-config" it boots up and comes as default configuration mode. it does not load the file configuration saved in XXX. as result its come as dump box and nothing else.
(C3845-ADVENTERPRISE0_IVS-M), version 12.(4)T7, RELEASE SOFTWARE (fc2).
i have checked the boot system its having the correct image and there is no changes have done on the router, Earlier it was working fine.
Any idea ?
Regards
Rajeev
Solved! Go to Solution.
12-23-2013 10:49 PM
hello Rajeev,
Can you please post the router current config and post the show ver from the command line.
Also check what is the confreg value under
router(boot)>show version
!-- This will be 0x2102 at the next reload. >>>>>>>>>> Ideally it should be same as defined here.
if not then change it.
Br,
Nadeem
Please rate all useful post.
12-23-2013 10:49 PM
hello Rajeev,
Can you please post the router current config and post the show ver from the command line.
Also check what is the confreg value under
router(boot)>show version
!-- This will be 0x2102 at the next reload. >>>>>>>>>> Ideally it should be same as defined here.
if not then change it.
Br,
Nadeem
Please rate all useful post.
12-23-2013 10:54 PM
just add one more thing to change the value, you need to go to global config mode
# config-register 0x2102
then save the configuration and try to load configuration and check if its working fine or not.
Br,
Nadeem
Please rate all useful post.
12-23-2013 11:45 PM
Yes, it showed as 0x2142 and changed the same now its working as earlier .Thanks for prompt response appreciate
Regards
Rajeev
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide