12-03-2015 08:52 AM - edited 03-08-2019 02:57 AM
Hi All,
Getting an CRC errors on all ports slot 3 line card 10/100BaseTX (RJ45)V.
IOS: cat4500-ipbasek9-mz.122-31.SGA9.bin
Did an RMA but also issue not resolved.
FastEthernet3/5 is up, line protocol is up (connected) | 96232 input errors, 7986 CRC, 0 frame, 0 overrun, 0 ignored | 2621 input errors, 718 CRC, 0 frame, 0 overrun, 0 ignored | 16112 input errors, 4533 CRC, 0 frame, 0 overrun, 0 ignored |
Need your help to resolve issue...!!!!
Solved! Go to Solution.
12-04-2015 05:14 PM
Since the answer was helpful to you, please rate and mark the post as answerd so others can benefit from it.
Thanks,
12-03-2015 09:08 AM
Hi,
Have you replaced any of the cables?
Do the devices connected to these ports have the right speed and duplex setting?
HTH
12-04-2015 03:09 AM
If same cable shift to another line card they are working.
Reza you are right its speed and duplex issue....Now issue got resolved after changing the speed and duplex setting to auto
12-04-2015 03:09 AM
If the same cables/device works fine on other card( I mean the other card doest report this messages) then could you please try to reseat ( Remove the module and insert it back) the card once?
Regards
Inayath
12-04-2015 05:14 PM
Since the answer was helpful to you, please rate and mark the post as answerd so others can benefit from it.
Thanks,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide