We are trying to use Security Center v184.108.40.206 to scan our network devices and get a successful Credential scan but am stuck as to how to troubleshoot.
In SC it has a username and password defined which is also created in AD. It is also placed in a security group to access the network devicse.
The account is setup to SSH and do cisco enable.
When we attempt to run the scan, it can get to the network device's IP and do some scans but it needs to authenticate into device to complete the scan. When we view the details, in the Credentialed Scan plug in, it does not load any Results.
It works if you create a local account on the device but we are trying to do it via ssh for sake of compliance and not have too many local accounts on the devices.
Hi,I would like to ask about ACL limitation on cisco switch.I read below info in nexus 1000v TShoot Guide. So let me it mean we cannot have more than 128 rule in an ACL in all cisco switches ?ACL Configuration LimitsThe following configuration limits appl...
ACL Configuration Limits
Currently when changing the Authentication Template under the Onboarding section, there is no choice but to remove SGTs, VNs and IP Pools which clearly disrupt existing services.
Hitless Authentication was introduced...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 220.127.116.11 as the RP for these groups:18.104.22.168/3222.214.171.124/32126.96.36.199/24188.8.131.52/16 R2 - "advertising" its loopback0 int...