Crossover chart

[stein9700]

I support a machine network over in the Netherlands and they are using Stratix 5700 - Rockwell Automation 1783-BMS10CGN.

It comes with the following features:

Stratix 5700 Switch, Managed, 8 Fast Ethernet Copper Ports, 2 Gigabit Ethernet Combo Ports, Full Software, CIP Sync, NAT, DLR

https://ab.rockwellautomation.com/Networks-and-Communications/Stratix-5700-Ethernet-Switches#selection

I have had several issues with how they are configuring these devices, my hope was to get one and setup a lab, but i am having issues with getting one.

My vendor is telling me there is a cross over model in the Cisco Line. 

https://www.cisco.com/c/en/us/products/collateral/switches/industrial-ethernet-2000-series-switches/datasheet-c78-730729.html

My main concern is the 1:1 ip nat rules they use.

I think the IE-2000-8TC-G-N should work has anyone tried this?

thanks

Mark

[pieterh · Accepted solution]

IE2000 series should be able to perform NAT

look at this information

[Mark Malone]

Just to confirm they do support NAT 1:1

https://www.cisco.com/c/en/us/td/docs/switches/lan/industrial/software/configuration/guide/b_l2_nat_ie.html