Solved: Re: CTS on IE4000

jeffatAdmin · ‎05-31-2023

I have 2 IE4000's. Both are Version 15.2(4)EA5. One allows me to program/configure CTS. The other doesn't recognize CTS as a command. I'm wondering what could cause 1 IE4000 to recognize the command and the other one with the same software version doesn't? I thought even if no configuration is placed on the switch when you type "?" it would at least show CTS, but it doesn't on the one. Would configuring CTS on the core switches they are connected to have any effect on not even seeing CTS as a recognized command at all? Any support is appreciated.

M02@rt37 · ‎05-31-2023

Hello @jeffatAdmin,

What about the licence on your two IE4000 switch? The same?

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.

View solution in original post

marce1000 · ‎05-31-2023

- Perhaps this is due to the lack of certain licenses on the particular device , check https://www.cisco.com/c/dam/en/us/solutions/collateral/enterprise-networks/trustsec/software-platform-capability-matrix.pdf , (look at the licenses column too) ,

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '