Debugging Algo boost / Warp mode

[homelabnoob]

I have a Nexus 3000 switch that is capable of Algo Boost / Warp mode that I want to debug that is kinda like debug ip packet detail or debug ip cef. What's the command to do this? Also, how do I send that debug output results on console or terminal monitor to syslog?

[Georg Pauwen]

Hello,

I have looked through all command references, it appears that the amount of 'debug' commands has been severely limited on the 3548. Which makes sense, since debugging uses a lot of CPU cycles and slows everything down. Especially since they market this model as being capable of 190 nanosecond packet switching speed due to the algo boost feature...

[homelabnoob]

Yea, I didn't see one either. Do you think Cisco TAC would know?