Debugging on Cisco 3850 XE 16.6.4

[alarsen]

Hi all

I’m struggling with the debug function on Cisco 3850 with 16.6.4 release

Where is the deb radius command, I found the deb aaa protocol radius, but I can’t see any output on the screen.

If I do show platform software trace message forwarding R0, I can see the radius in this file. But this is page by page

But how do get online data or can I do something like tail on the file.

I the good old days, we could download a full command reference of the complete OS, isn’t that possible anymore

/Arne

[balaji.bandi]

IOS XE also have command reference :

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3850/software/release/16-6/command_reference/b_166_3850_cr.html

[alarsen]

I found that document, but I can’t find the syntax for the old debug radius command that can be shown on the stdout.

How do I do real time debugging on radius, dot1x, mab etc. request.

[rasmus.elmholt]

You do use the terminal monitor command right?

[alarsen]

Yes, I think I do, can you get the radius request from a specific interface shown on the console.

All trace as I see ends up in the trace files under them platform specific processes.

I can see the request and answer in those files. I can also set the debugging levels there.

This command gives me the right output, but not online.

Show platform software trace message smd switch active r0 reverse

If I do debug radius I only see the requests for the control plane.

/Arne