I have two distribution switches and a single access layer switch. I want to configure the access switch to connect my APs. I would like to configure the access switch to connect to both distribution switches. I was working with vPC in another lab, so I'm used to setting up a vPC upstream from say a N2K. So this is using Catalyst switches in a lab, 3750s and 3560 to be exact.
If I am not mistaken, I will only be able to configure a port-channel to each distribution switch. Then I would configure HSRP at the distribution layer? I'm a little fuzzy on how to configure the access switch. I believe I just configure the individual port-channels to each distribution switch as a trunk, then if one of them fails, the HSRP configuration at the distribution layer will act accordingly. Is this correct?
