07-27-2012 08:43 PM - edited 03-07-2019 08:01 AM
Hello, on a 2960 switch, is the default switchport mode 'dynamic desirable' ?
How can I see what the swtichport mode is. When I do a 'show run' nothing regarding switchport modes is visible ?
Thanks for any help.
07-27-2012 11:45 PM
Hi,
Yes, it's the default switch port setting. Cisco device IOSs normally don't display the default setting/command in the show run.
Issue a 'show interface x/x switchport' command to verify on which mode it's in.
Sent from Cisco Technical Support iPhone App
07-28-2012 09:16 AM
hi, you can use show int status this is shows all interfaces status
07-28-2012 10:18 AM
Hi Philip,
John is correct.
sh interfaces switchport brief
It will show an output like the below
Port Status Op.Mode Op.Encap Channel-id Vlan
Te1/1 connected trunk 802.1q -- 201,207
Te1/2 connected trunk 802.1q -- 201,207
Te1/3 disabled none native -- 201
Gi2/1 notconnect none native -- 201
Gi2/2 notconnect none native -- 201
Gi2/3 connected access native -- 201
Please do rate if the given information helps.
By
Karthik
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: