Hello, Daniele!
Thanks for help.
I did this configurations with no problems, but the incoming\outcoming calls are not works. The following situations occurs:
- For Incoming calls: When i call to PBX from another number, is muted and then ends after some seconds;
- For outcoming calls: when i try to do some call, i need to insert the number "0" before the destination number, rigth? so i put 0 and the destination number and i received a mensage from the telcom company, that was not possible to complete the call.
I changed the lines above with my configuration, but im not sure if i did rigth. Can you help me?
dial-peer voice 10 pots
description OUT to PSTN
destination-pattern .T
direct-inward-dial
port 1/0:15 !### i changed for: port 0/0/0:0 (0/0/0 its my port and : 0 its my ds0-group. )
dial-peer voice 11 voip
description IN from PSTN
translation-profile incoming XLATE_PUBLIC_NUM
destination-pattern XXXX92[5-8]. !### i changed for my number without the area code and region code, i need to insert my full number ?
b2bua
modem passthrough nse codec g711alaw
session protocol sipv2
session target ipv4:10.0.0.1 !### ok, i changed without problems
session transport udp
incoming called-number XXXX92[5-8]. !### i changed for my number without the area code and region code, i need to insert my full number ?
dtmf-relay rtp-nte
codec g711alaw
fax rate disable
fax protocol pass-through g711alaw
no vad
Probably you must use a translation rule to convert your public phone numbers to ephone numbers:
voice translation-rule 1
rule 1 /^XXXX92/ /92/ !### i changed for my number without the area code and region code, i need to insert my full number ?
!
!
voice translation-profile XLATE_PUBLIC_NUM
translate called 1
