EIGRP not send to neighbors changes in delay values

[Jose Nicolas Tomsich]

Hi people.

I need your help. I have a problem when a try to change de route of EIGRP.

When i insert the command delay 300 (for example) in the subinterface, i can see the change where type the command "show interface g0/1.xxx", in the line DLY 3000 usec. But, in the neighbors, allways see "Total delay is 20 microseconds"

Which can the cause?

I remember that work!!.

The neighbors are connected beetwen then through Lan-to-Lan.

I expect your answer.

Greeting

[Rolando Valenzuela]

Have you check your K values?

Are you using redistribution at any point?