I have 10 new 4506E chassis with WS-X45-SUP8L-E sup module that I need to configure. I do not have 10GB to my Distribution yet. What command do I use to enable the sup's interface to recognize GB instead of 10gb? The sup6 or sup7 command "hw-module uplink gigabitethernet" does not work on the Sup8. My Fw/OS is: 15.1(1r)SG6 / 03.08.03.E
Sw1#sho int status
Port Name Status Vlan Duplex Speed Type
Te1/1 notconnect 1 full auto No XCVR
Te1/2 notconnect 1 full auto No XCVR
Te1/3 notconnect 1 full auto No XCVR
Te1/4 notconnect 1 full auto No XCVR
Sw1(config)#hw-module ?
beacon Apply hw-module command to beacon LED
module Individual module in the system
module Specify a linecard slot for the hw-module command
slot Specify a linecard slot for the hw-module command
system Specify the system parameter