Enable QSA (10GB) adapter on a QSFP+ port on a Nexus 93108TC-EX

[Morris Stevens]

I believe that there needs to be a speed-group applied to one of the six ports QSFP+ ports (49-54), but I have so far been unable to apply a speed-group setting to any of the ports. Looking for some assistance to get this QSA to come up, as right now it remains down.

[Reza Sharifi]

Is the speed command under the interface unavailable? 

What is the error message you are getting?

[Morris Stevens]

Thanks for your reply!!

I unplug the QSA, and then set the speed for that port to 10000, the device accepts the command. When I plug the QSA back in, it actually stopps being in error, but the link remains down, and I cannot perform a noshut on it and have it come up. When I try and set speed-group 10000 (what I have read for similar switches), I get the message "Configuration does not match the port capability"

[Reza Sharifi]

Thanks for the info.

What are you connecting the Nexus 93108 to? What is on the other side of the fiber?

[Morris Stevens]

Thanks again!

It plugs in to a 4900M with a OneX/X2 with a SFP-10GB-LR (mated pair to what is installed in the QSA)

[Morris Stevens]

bump!