enable switch reset and password
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-23-2022 06:43 AM
Good morning!
I have a Cisco Catalyst 2960-X Series switch. I can't get it back. My problem is I don't remember the "enable" password I set. Is there any way to recover this password? Or just reset the switch. If it's just resetting it, like I do. Because I have read the datasheet, I have seen videos on youtube how to reset it, and I can not in any way. It always comes back with the same name (hostname) and always asking to authenticate with the "enable" password.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-23-2022 08:49 AM
- FYI : https://www.router-switch.com/faq/cisco-2960-series-password-recovery.html
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-23-2022 09:33 AM
You not enter rommon mode so you still face same issue
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-23-2022 11:15 PM
You need to perform a "Password Recovery" procedure. Marce1000 has provided a link. You can also check on Cisco.com or numerous other sites.
