08-03-2007 03:49 AM - edited 03-05-2019 05:41 PM
The status of the fast ethernet port is showing err-disabled.So I need to enable a port in cisco 2950 switch.Kindly let me know how to proceed.
Solved! Go to Solution.
08-03-2007 03:50 AM
Hi Friend,
You can simply shut and unshut the port and it will come up. But it is better to find out what is the reason for the interface going into errdisable state.
Can you check the logs and see if it tells you the reason? If logs does not show you you can configure errdisable detect command to detect the reason.
Also this is the link to configure erridsbale recovery
Regards,
Ankur
*Pls rate all helpfull post
08-03-2007 03:50 AM
Hi Friend,
You can simply shut and unshut the port and it will come up. But it is better to find out what is the reason for the interface going into errdisable state.
Can you check the logs and see if it tells you the reason? If logs does not show you you can configure errdisable detect command to detect the reason.
Also this is the link to configure erridsbale recovery
Regards,
Ankur
*Pls rate all helpfull post
08-03-2007 03:58 AM
Thanks !!.It works.
08-03-2007 03:53 AM
Hi
issue the following commands for example for Fa 0/1
Switch#
configure terminal
interface Fa 0/1
no shut
end
HTH
Regards
Shaheen
*****Sorry Ankur....i saw your post after posting mine. Your links are very helpful and rated accordingly. People like you make these forums very useful. thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide