03-03-2011 09:05 AM - edited 03-06-2019 03:52 PM
Please review the attachment. I have the netflow baseline configured, but can't enable it on Fa4/48. This there a different command?
Samlpe link or sample configuration would be greatly appreciated. Thanks.
03-03-2011 09:58 AM
Try the below commands
ip route-cache flow
ip flow ingress
I hope the below link will help with the config
03-03-2011 11:52 PM
Hi,
You need to configure the port like below to be able to sent stats to netflow server.
interface FastEthernet4/48
description juniper_ssg550; 10.25.96.254; lan0
bandwidth 45000
load-interval 30
switchport
switchport access vlan 96
switchport mode access
ip flow ingress
You must enable only ip flow ingress or ip flow egress as per best practices.
If you enable both on single interface then the data will club and give you improper results like club all the data incoming and out going like that.
Please rate the helpfull posts.
Regards,
Naidu.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide