Erased nvram

[Ed Lo]

Hello,

I'm using a 1941w router and the default gatway to access the gui through a browser is 10.10.10.1 . As I'm new at using it I was learning how to do things and so to make things go back to normal I looked at how to reset and erased the nvram. Now when I connect an ethernet cable to get to the gui it does not connect. Is there anyway I can return this to normal?

Thank you

[Reza Sharifi]

Hi,

You basically erased the config.  Now you need a console cable to logon to the device via the console port and put the IP address back (10.10.10.1), so you can access it via gui.

HTH

[Ed Lo]

Would the IP address be put on the the configuration of the Ethernet port?

[Reza Sharifi]

Yes, assign the same IP to the same interface, so you can logon to it via gui.

Also, make sure ip http server is configured on the device.

HTH