03-03-2016 08:29 AM - edited 03-08-2019 04:49 AM
hi,
i can find many information how to auto-recover a port with enabled errdisable recovery on a cisco 2960x.
But how can disable the timer for a special cause.
thanks for answers
gunther
03-03-2016 08:35 AM
Hi
if you don't want err-disable to kick in , just do a no infront of it or maybe set the intervals longer to pause the recovery
CORE.CA.23(config)#errdisable recovery interval ?
<30-86400> timer-interval(sec)
03-03-2016 10:12 AM
moving this discussion to the appropriate community for greater visibility.
03-04-2016 02:59 PM
Hi Karlstetter1,
Disabling the timer for a particular cause it's easy, just go with:
Switch(config)#no errdisable recovery cause <cause>
You cannot configure different timer intervals for different causes,though. One time interval will rule all the causes.
Hope it helps.
AJ
03-07-2016 03:03 AM
Hi Adrian,
thanks a lot!
Sometimes the solution is just to near to see it.
Thank you
gunther
03-07-2016 05:09 AM
Sure anytime!
AJ
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide