etharchannel in two different switch

[bkshrestha]

i want to load balancing two different cisco switch. how it is possible.

two switch meaing:

sw1 is connected from fiber in l3 switch.

sw2

sw3

sw4 is connected from cat6 in l3 switch

so i would like to eharchannel in sw1 to l3, s1 to sw2, sw2 to sw3, s3 to sw4 and sw4 to l2 switch from cat6.please suggest.

[Tom Watts · Accepted solution]

What switch model #?

-Tom
Please mark answered for helpful posts

[bkshrestha]

l2 switch is c2960

l3 is c3750

[Tom Watts]

Bikash, so long as the config matches there should be no problems. You may make the channel-group, assign to the group number you want, I'd recommend to use mode "on" instead of active or passive. This will make a static LAG.

The one thing to take notice of, when you make the LAG between switches, you may make the ports go in to err disable. Just shut/no shut the ports once the config is complete to bring the lag up accordingly.

so something like

config t

int range xxx

channel-group 1 mode on

-Tom
Please mark answered for helpful posts