03-20-2015 07:40 AM - edited 03-07-2019 11:10 PM
Hi,
I am trying to get into some depths of how a etherchannel on Cisco switch works.
My question is how is the RBH value calculated?
I issue this command on a Cisco C6807 switch and have the below output.
sw-core-ind-pun4-b1f6s1#test etherchannel load-balance interface port-channel 90 ip 192.168.1.1 192.168.1.2
Computed RBH: 0x3
Would select Te2/5 of Po90
How did the calculation work?
Thanks,
Neel
Solved! Go to Solution.
03-20-2015 07:46 AM
This document should answer your question -
https://supportforums.cisco.com/document/69496/etherchannel-loadbalancing-catalyst-switches
Jon
03-20-2015 07:46 AM
This document should answer your question -
https://supportforums.cisco.com/document/69496/etherchannel-loadbalancing-catalyst-switches
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide