Hi community,
Some peaple know if with this lines I can configure a etherchannel LAG between one WLC 2504 and 2 Switch´s 4500 in mode VSS?
This configuration is on the WLC 2504:
interface GigabitEthernet <interface id>
switchport
channel-group <id> mode on
no shutdown
And this configuration is on the VSS.
interface port-channel <id>
switchport
switchport trunk encapsulation dot1q
switchport trunk native vlan <native vlan id>
switchport trunk allowed vlan <allowed vlans>
switchport mode trunk
no shutdown
In the WLC I have 3 interfaces, managment (VLAN 10) SSID RH-DATOS, voip-interface (VLAN 20) RH-VOIP, virtual-ip interface, so, if I active in the GUI WLC the option LAG and in the console I configure the etherchannel is possible that the configuration of these two ssid´s can be erased?
Regards and thank you!