Failed to access web ui after configure new IP

[pantulu]

Hello,

I have Cisco Switch C9200L-24T-4G. I have configure this new switch using classic day 0 wizard.

After finish, reboot the switch but unable to access web UI using new IP address. Configuration summary attached in the picture. 

How to fix this issue?

Thanks.

[M02@rt37]

Hello @pantulu 

Does ip http server command is configured ?

Through CLI configure this:

switch(config)# ip http server
switch(config)# ip http secure-server
switch(config)# ip http authentication local

[MHM Cisco World]

Did you change the PC IP to match new subnet of mgmt ?

MHM

[pantulu]

I have change PC IP match with the new IP of switch. Still unable to open web ui.

[Georg Pauwen]

Can you ping the switch from your PC ?

[balaji.bandi]

The configuration in the Management port - is the PC connected back to back on MGMT port ? (not the switch ports)

If you have not configured VLAN 1 IP address - Your switch port you connected to PC may not work.

You have console cable - connect the console cable and check is the configuration saved - and follow below video easy.

https://www.youtube.com/watch?v=lTb3Nbzhpjw

Also check Zero days :

https://video.cisco.com/detail/video/5988297857001