05-07-2012 07:34 PM - edited 03-07-2019 06:34 AM
Hi NetPro,
i have noticed that the FAN PS-2 is not present , is that a way to resolve this ?
sh env all
FAN 1 is OK
FAN 2 is OK
FAN PS-1 is OK
FAN PS-2 is NOT PRESENT
TEMPERATURE is OK
Temperature Value: 38 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 46 Degree Celsius
Red Threshold : 60 Degree Celsius
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1A C3KX-PWR-1100WAC LIT14240HHZ OK Good Good 1100/0
1B Not Present
2A C3KX-PWR-1100WAC LIT14240HMF OK Good Good 1100/0
2B Not Present
3A C3KX-PWR-1100WAC LIT14240HMD OK Good Good 1100/0
3B Not Present
4A C3KX-PWR-1100WAC LIT14240HPG OK Good Good 1100/0
4B Not Present
SW Status RPS Name RPS Serial# RPS Port#
-- ------------- ---------------- ----------- ---------
1 Not Present <>
2 Not Present <>
3 Not Present <>
4 Not Present <>
Regards,
Jack
05-07-2012 08:44 PM
I believe this is an IOS bug.
05-07-2012 09:58 PM
Hi
FAN PS-2 = The fan of Powersupply 2 is not present.
The reason that the fan of PS2 is not present is that the powersupply in slot 1B is not present.
So its a kind of stupid message telling you that the fan in powersupply 1B is not responding properly to an "I am ok" signal.
But how could it ? There is no powersupply in 1B. No powersupply=no fan installed, no fan installed = no "I am ok" signal.
so it is kind of a "bug" that it does not state "not installed"
I think it have something to do with that it would be hard to know if the PS-2 or the fan in PS-2 is not installed or just broken in a way that no signal is responded to.
Good luck
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide