Firepower Threat Defense FMC Loopback Address

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-18-2018
07:31 AM
- last edited on
03-25-2019
04:48 PM
by
ciscomoderator
Is there a way to set a traditional loopback address in FMC? I would like to use a loopback address for solwarwinds management and troubleshooting but have been unable to find a way to configure one via the fmc.
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-18-2018 03:09 PM
The FMC is a host. And with that it has one IP that is also used for management. Same for your FTDs, the management-IP is also a host-address and can be accessed from your management-stations. This is completely different to a L3-switch or router where you can have multiple IP-interfaces with different ways to reach these interfaces.
