Hi All.
I configured Flexible Netflow on my Cisco ASR 1002-X with IOS XE asr1002x-universal.03.11.00.S.154-1.S-std.SPA.
Netflow configured for collect input and output statistics, however output works only.
I see only output traffic.
My config:
flow exporter BILLING
destination 10.254.81.70
source Loopback0
transport udp 9996
export-protocol netflow-v5
flow monitor S3P-NETFLOW
exporter BILLING
cache timeout active 60
record netflow-original
interface GigabitEthernet0/0/2.200
encapsulation dot1Q 200
ip vrf forwarding test
ip address 10.250.191.1 255.255.255.252
ip flow monitor S3P-NETFLOW input
ip flow monitor S3P-NETFLOW output
ip ospf message-digest-key 10 md5 7 xxxxxxxxxxxxxxx
ip ospf mtu-ignore
My results:
#show flow monitor S3P-NETFLOW cache format table | include 10.162
10.254.106.42 10.162.64.10 11135 27343 Gi0/0/0 0 0xC0 50 13105 0 10.250.191.2 /24
/30 0x00 Gi0/0/2.200 136 1 02:44:32.071 02:44:32.071
10.254.106.42 10.162.64.2 42046 46441 Gi0/0/0 0 0x00 50 13105 0 10.250.191.2 /24
/30 0x00 Gi0/0/2.200 11008 24 02:44:24.635 02:44:45.451
10.254.106.42 10.162.64.2 42046 46441 Gi0/0/0 0 0xC0 50 13105 0 10.250.191.2 /24
/30 0x00 Gi0/0/2.200 136 1 02:44:37.867 02:44:37.867
10.254.106.42 10.162.64.10 11135 27343 Gi0/0/0 0 0x00 50 13105 0 10.250.191.2 /24
/30 0x00 Gi0/0/2.200 2872 19 02:44:28.185 02:44:43.667
10.254.106.42 10.162.64.6 43539 35007 Gi0/0/0 0 0x00 50 13105 0 10.250.191.2 /24
/30 0x00 Gi0/0/2.200 272 2 02:44:44.651 02:44:44.731
Thanks.
Konstantin